I  had help with putting the front suspension back on the car. My son Chris and even my wife Barb came out to help on the project.  I made my own spring compressor using a 3/8” threaded rod, 2 blocks of 1” pieces of wood, and several large washers. I put the rod through the top shock mount hole and put the blocks under the lower front control arm. The front of the A arm was connected to the spindle and all I had to do was tighten the nut up on the lower A arm to raise the back of the arm into place. Since the car frame had no engine the spring was not that tightly compressed and slipped right into place in less then twenty minutes on each side.  All of the suspension parts have been replaced with poly urethane bushing front and rear.